POWER AMP 5CH HERTZ EP-5

  Output Power (RMS): 60W x 4 + 160W x 1 @4-ohm 95W x 4 + 250W x 1 @2-ohm 3 channel mode: 190W x 2 (4ohm) + 160W x 1 (4ohm) 190W x 2 (4ohm) + 250W x 1 (2ohm) Filters & Controls: A Channels: Full / Hi-pass / Lo-pass: 40 - 150Hz @12dB/Oct B Channels: Full / Hi-pass / Lo-pass: 40 - 150Hz @12dB/Oct C Channels: Lo Pass 40 - 150Hz @24dB/Oct T.H.D. (100Hz @4-ohm): 0.08% Bandwith A & B (-3 dB): 7 - 60Hz Bandwith C (-3 dB): 7 - 150Hz S/N Ratio (A weighted @1V): 98dBA Damping Factor A & B Channel (100Hz @4-ohm) :100 Damping Factor C Channel (100Hz @4-ohm) :200 Pre-In sensitivity: 0.3-5Volts Pre-In impedence: 15 kohms Speaker-In sensitivity: 1.4-24Volts Speaker-in impendence@ 5kOhms Power supply voltage: 11 - 15Volts Idling current: 1.5A Idling current when off: 0.04mA Consumption @4ohm, 14.4VDC: 44A Remote In: 6-15 VDC - 1mA Remote Out: 12 VDC - 50mA Automatic Turn On/Off with speaker in Fuse: 3x30A Dimensions (mm): 240 x 450 x 54 The EP 5 is a multi-channel amplifier, offering power output of up to 630W!  Using a special switch for a fast configuration into 3-channel mode, the EP5 delivers  190W x 2 (4 Ohm) + 250W x 1 (2 Ohm). The C channel is dedicated to drive the subwoofer. For this reason, it features one single high power stage. The power supply section is equipped with two multi-winding toroidal core transformers along with Low ESR 105°C capacitors, ensuring very high efficiency. The EP 5 boasts extreme reliability thanks to the use of FR-4 double layer PCB material. 70µm thick copper traces in combination with robust copper bars are used for paths with high current transfer. Advanced electronics and optimized cooling system allow the EP 5 to provide high power, even under difficult conditions